Cold Laminator Signs Made Simple

Place the over-laminate panel on a flat work surface with the covered adhesive side face up.

Position the toothed STRIPPER TOOL with the head of the T-bar in line with the panel edge.

Tear off a 20mm strip of the polythene cover. You will find that pulling the polythene ON TO the sharp teeth makes this easy.

Place the over-laminate panel into the REGISTRATION TRAY.

Ensure that the exposed adhesive strip is NOT at the end of the panel which is fitted snugly into the corner of the tray.

Introduce the printed matter into the tray by locating it into the corner and lower onto the panel surface.
The REGISTRATION TRAY ensures that no part of the printed matter will come into contact with the exposed adhesive strip until the print and the panel are in perfect alignment.

A simple stroke across the print where it touches the exposed adhesive on the panel will guarantee that the print and the panel remain a ‘tacked’ set in perfect alignment ready for step 3.

Advance the 20mm ‘tacked’ end of the set into the ROLI-POLI laminator rollers. Do not exceed the 20mm.

Lift the CAT-FLAP and pass the printed matter underneath.

Return the CAT-FLAP to its ’flap-down’ position.

Now that the printed matter is isolated, expose the adhesive surface of the panel by removing the remainder of the polythene cover.

Turn the ROLI-POLI handle clockwise to pass the printed matter and panel set through the rollers.

As these cannot come into contact with each other until they meet at the roller ’nip’ this ensures that no air can be trapped during the laminating process.

The completed sign will exhibit a perfectly aligned, bubble-free finish.